Date: Sat, 3 Sep 1994 03:55:03 -1000 From: peterr@gds.nl (P. Ruinard) Message-Id: <1994Sep3.135503.1612@gds.nl> Organization: GDS BV, PObox 473 Delft, The Netherlands.. Subject: Error list Stunt Kites II ***************************************************************** * * * STUNT KITES II * * New Designs, Buggies and Boats. * * * ***************************************************************** Corrections and additions: First edition 22 august 1994 SPEEDWING: Page 64 Figure 1 29 cm should be 56 cm Page 65 Figure 3 2.5 cm should be 3 cm Page 67 Speedwing 3x1 aluminium ring: 32 cm from nose bridle clips: approx. 56 cm from hole on leading edge LA HEMBRA: Page 68 Figure 1 measurements D and E: 80 mm G1: 400 mm from A 880 mm should be 900 mm 882.5 mm should be 910 mm 240 mm should be 230 mm 23 mm should be 33 mm EL MACHO: Page 72 Figure 1 18 mm (lower left) should be 12 mm 33 mm (lower left) should be 37 mm G1: 530 mm from A KRYPTON-S: Page 76 Figure 1 36 mm (upper left) should be 26 mm SPUTNIK 4: Page 79 Figure 1 gauze fabric: 312 cm should be 472 cm Page 84 Figure 12 X and Y should be reversed Page 85 Figure 15 X and Y should be reversed Page 86 Figure 20 arc measurements missing: from top to bottom: 4, 11, 22, 37 and 57 cm ----------------------------------------------------------------- This is the erratum for the book STUNT KITES II New Designs, Buggies and Boats by Servaas van der Horst and Nop Velthuizen. This erratum is valid for the Dutch, English and German version of the book. I will also try to put this erratum on the tfp.hawaii.edu = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = Date: Wed, 7 Sep 1994 22:12:26 -1000 From: pettsj@visigoth.demon.co.uk (James Petts) Message-Id: Organization: Unlikely... Subject: Re: Error list Stunt Kites II In article <1994Sep3.135503.1612@gds.nl>, peterr@gds.nl (P. Ruinard) wrote: > ***************************************************************** > * * > * STUNT KITES II * > * New Designs, Buggies and Boats. * > * * > ***************************************************************** > > Corrections and additions: First edition 22 august 1994 <> Another error is in the trailing edge measurement of the small Zipp. The length of the trailing edge should be 50 cm (add 16 cm for the piece cut off at the right angle for a total of 66 cm). The measurements give 66 + 16 = 82 cm. This can be verified by calculation, and the fact that the big Zipp should be exactly twice the size of the small. -- James Petts ----------- DO NOT READ THIS .sig UNDER PENALTY OF LAW! FUTILE CODE SECTION 4 SUBSECTION A.1.7 = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = =